If your home is going to be renovated, I believe I will read all kinds of decorative articles, but I do n’t have more than one line of decoration knowledge for everyone today, but after reading it, you will definitely realize it! Well, without further ado, quickly follow the golden mango decoration editor to take a look at these 100 common tips for decoration that you need to pay attention to during actual decoration!

I. Hydropower

1. The waterproofing works should be done after the concealed works are completed and accepted

2. The waterproof construction should use waterproof coating

3. After the waterproof construction is completed, two water storage tests shall be performed

4. The bathroom waterproof layer should be no less than 1.8 meters

5. The floor drain, yin and yang corners, pipes and other places should be waterproofed once more

6. Floor drain should use deodorant floor drain

7. The hot and cold water pipes are left hot and cold right

8. Try not to walk the water pipe from the ground

9. The cold water pipe must have a protective layer of 1CM in the wall, and the hot water pipe is 1.5CM, so the groove must be deep

10. When installing the PPR tube, it is necessary to consider the thickness of the tile so that the tube will not be exposed

11. It only takes a few minutes to cook the dishes. It takes a long time to wash the dishes.

12. The faucet and washbasin must be matched.

13. Cement cannot be used for toilet installation, use silicone

14. Pay attention to protection after installing the toilet and faucet

15. When buying a toilet, consider the pit distance of the toilet

16. The washing machine should consider whether it is drained up or down

17. It is better not to install a telephone in the bathroom, it is easy to get wet

18. The size of the mirror in the bathroom must be considered first, otherwise the front light of the mirror can be easily installed high

19. It is best to leave manholes for toilet pipes

20. Strong and weak electricity cannot be worn in the same tube

21, left zero, right phase ground

22. The power socket is 300 meters away from the ground, the switch is 1.4 meters

23. Do not install the switch behind the door

24, a lot of sockets should be good

25、16A socket for high-power electrical appliances, such as electric oven, etc.

26. The cassette should be used well

27. The cassette must be matched with the panel, otherwise it may not be installed

28. The cross-sectional area of the wire in the PVC wire tube should not exceed 40% of the cross-sectional area of the wire tube

29. The air conditioner in the bedroom should not be on the bed

30. The air-conditioning hole should be tilted outwards, otherwise rain will come in

31. The lamp should consider dual control as much as possible

32. It is better to install splash-proof socket in the bathroom

33. Consider a socket on the balcony

34. The wire trough should be horizontal and vertical, and the photos should be arranged well.

35. Check valve should be installed in public flue

36. The purchased electrical appliances must let the workers read the instructions

37. The manual and warranty card must be kept

Second, the mason

38. Cement cannot be used after three months

39. Cement of different varieties and labels can not be mixed

40. Yellow sand must use river sand, taste it with your mouth.

41. The wall and floor tiles should be immersed in water for more than two hours.

42. It is better to buy a few more pieces of wall and floor tiles than to buy less, otherwise it is easy to appear color difference

43. There can be no two rows of non-whole bricks on one wall

44. Clean the tiles immediately after wiping

45. The ground is covered with marble (light color), the back of the stone should be waterproof

46. Cut 45 degrees at the positive corner

47. Floor tiles should be inclined to the floor drain, otherwise water will easily accumulate

48. The wall brick meets the pipe mouth to adopt the form of sleeve cutting, so it looks like a whole brick

49. Floor marble should be dry paved

50. Floor tiles must be dirt-resistant and non-slip, do not just look good

51. Matt tiles are difficult to clean

52. Pay attention to the drainage direction of balcony tiles

3. Carpentry

53. It is best to use dried larch

54. When you buy large wood board, you have to saw it and dry it.

55. Woodworkers must first play the house horizontal line

56. As soon as the color panel comes in, you must buy a paint brush to prevent it from being stained

57. Ceiling fan cannot be installed on the ceiling keel

58. The color panel should be pre-selected during construction

59. The distance between the hanger of the suspended ceiling and the wall should not exceed 300

60. The gypsum board should be fixed with countersunk head tapping screws, enter the board surface 1 ~ 2MM, and do anti-rust treatment

61. The distance between the nails of the gypsum board should not exceed 200

62. The gypsum board should have a 3MM seam with the wall for crack prevention treatment

63. It is better to protect the corner of the plasterboard by the corner

64. Paint up and down the top and bottom of the wooden door

65. The bottom of the bathroom door cover should be brushed for waterproofing

66, the size of the door should be consistent

67. Try not to let the woodworkers do the furniture, and do not do well

68. Try to buy the whole cabinet as much as possible

69 、 All sizes must be considered, it will be more troublesome to change

70. Don't make a dark track for the sliding door made by yourself, you can't repair it in the future

71. If the bathroom is small, try to move the door as much as possible, do not open the door, take up space

72. Carpenters who are inaccurate must communicate more with the foreman, and never let them make their own claims

73. Money is the last word

74. There are children at home, so use less glass

75. Be sure to let the workers read the drawings

76, the kitchen drawer is very useful

77, the flatness of the floor wooden keel is 5MM

78. The floor should be laid at 30 degrees or 45 degrees, leaving 2 ~ 3MM between the boards and the seams should be staggered

79. Leave 8 ~ 10mm gap between the floor and the wall

80. Expansion joints should be considered when the length of composite floor exceeds 8M

81. Minimize the use of MDF for door covers

82 、 Hinges and hardware must be used well

83. Yuba should be installed on the wooden keel, not directly on the ceiling

Fourth, the painter

84. Do not mix water during the construction of medium and dark color latex paints, otherwise color difference is prone to occur

85. Bandages on the joints of gypsum board

86. It is better to put a cool cloth on the wall where there is a gap

87. The original putty on the wall is best to be shoveled out or brushed with glue to seal

88. Try to buy paints from well-known brands. Do n’t use those that are not recommended by the decoration company or foreman.

89. The weather is too humid, do not paint

90. The paint and coating should be polished completely

91. The next paint construction must wait for the previous paint to dry out

92. The paint on the metal surface should be treated with anti-rust

93. The weather is too cold, the paint construction quality will be poor

94. When painting the door, use hinged paper to attach the hinge and door lock

95. It is too hot, pay attention to ventilation

96. When applying wallpaper, brush the wall with oil

97. When attaching wallpaper, remove the panel of the switch and socket

98. The gloss and mercerized latex paint should be completed at one time, and the color difference is prone to be made

99. After the baseboard is installed, use putty and latex paint to make up the seam.

100. Frosted glass should be protected with newspaper